O2 Innovations pmn - Manual (Page 34)

TARGET Series ENMET Corporation
31
11.0 WARRANTY
ENMET warrants new instruments to be free from defects in workmanship and material under normal use for a period
of eighteen months from date of shipment from ENMET . The warranty covers both parts and labor excluding
instrument calibration and expendable parts such as calibration gas, filters, batteries, etc... Equipment believed to be
defective should be returned to
ENMET within the warranty period (transportation prepaid) for inspection. If the
evaluation by ENMET confirms that the product is defective, it will be repaired or replaced at no charge, within the
stated limitations, and returned prepaid to any location in the United States by the most economical means, e.g.
Surface UPS/FedEx Ground. If an expedient means of transportation is requested during the warranty period, the
customer is responsible for the difference between the most economical means and the expedient mode.
ENMET shall
not be liable for any loss or damage caused by the improper use of the product. The purchaser indemnifies and saves
harmless the company with respect to any loss or damages that may arise through the use by the purchaser or others of
this equipment.
This warranty is expressly given in lieu of all other warranties, either expressed or implied, including that of
merchantability, and all other obligations or liabilities of
ENMET which may arise in connection with this equipment.
ENMET neither assumes nor authorizes any representative or other person to assume for it any obligation or liability
other than that which is set forth herein.
There are Return for Repair Instructions and Form on the last pages of this manual. This Form can be copied or used
as needed.
Manual Part Number
80012-014
July 1999
Updated September 1999
MCN-225; 12/16/99
MCN-235; 07/12/00
MCN-245; 09/26/00
MCN-250; 03/20/01
MCN-263; 08/22/01
MCN-275, 05/01/02
MCN-289, 11/22/02
MCN-302, 09/04/03
MCN-305, 09/16/03
MCN-337, 07/27/05
MCN-366, 06/20/07
MCN-380, 11/07/07
Notes: