Onkyo TX-SR502 - Manual (Page 37)

37
Using the Tuner —Continued
You can store up to 30 of your favorite radio stations as
presets.
When the input source is AM or FM:
When tuned to an RDS radio station broadcasting PS
information (European models only):
*This information is displayed for about five seconds,
then the previously displayed information reappears.
Presetting Radio Stations
1 Tune into the station that you
want to store as a preset.
2 Press the [MEMORY] button.
The MEMORY indicator appears and
the preset number flashes.
3 While the MEMORY indicator is
displayed (about 8 seconds), use
the PRESET [
]/[ ] buttons to
select a preset from 1 through 30.
In this example, preset #3 is selected.
4 Press the [MEMORY] button
again to store the station.
The station is stored and the preset
number stops flashing.
Repeat this procedure for all of your
favorite radio stations.
Selecting Preset Stations
1 Use the [TUNER] input selector
button to select either AM or FM.
2 Use the PRESET [ ]/[ ] but-
tons, or the remote controller’s
CH [+/–] button to select the pre-
sets.
TUNING MODE MEMORY
CLEAR
PRESET
TUNING MODE MEMORY
CLEAR
TUNER
PRESET
Deleting Presets
1 Select the preset that you want to
delete.
See the previous section.
2 While holding down the [MEM-
ORY] button, press the
[TUNING MODE] button.
The selected preset is deleted and its
number disappears from the display.
Displaying Radio Information
1 Press the [DISPLAY] button
repeatedly to cycle through the
available information.
TUNING MODE MEMORY
CLEAR
DISPLAY
Band, frequency
& preset #
Band &
listening mode
Station name
& preset #
Band, frequency
& preset #*
Band &
listening mode