Onkyo CR-315DAB - Manual (Page 25)

25
Connecting Other Components—Continued
Connect the CD receiver’s LINE 1 IN jacks (use the DOCK IN jacks on the CR-315DAB) to the TV’s audio output
jacks.
Hint:
To listen to the TV, select the LINE 1 input source (select DOCK on the CR-315DAB).
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the CD receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the CD receiver into a different branch circuit.
• Do not use a power cord other than the one supplied with the CD receiver. The supplied power cord is designed
exclusively for use with the CD receiver and should not be used with any other equipment.
• Never disconnect the power cord from the CD receiver while the other end is still plugged into a wall outlet. Doing
so may cause an electric shock. Always disconnect the power cord from the wall outlet first, and then the CD receiver.
To set the clock with the AccuClock function, the CD receiver must be able to receive RDS radio stations, which means
an FM antenna must be connected (see page 16).
Connecting a TV
I N
I N
R
LINE 1
MD/
TAPE
L
I N
OUT
OUT
DOCK/
CDR
: Signal flow
CR-515DAB’s
rear panel
White
Red
Red White
Analog audio cable (RCA)
TV
Connecting the Power Cord
1
2
1
2
To wall outlet
Supplied power cord
CR-315DAB CR-515DAB
To wall outlet
Supplied power cord
1 Connect the supplied power cord to the CD receiver’s AC INLET.
2 Plug the power cord into a suitable wall outlet.
The STANDBY indicator lights up.