Onkyo CR-445 - Manual (Page 39)

Using the Timers—Continued
39
Turning Timers On and Off
Once a timer has been programmed, you can turn it
on or off as necessary. For example, while you’re on
holiday, you may want to turn off the timer you use
as an early-morning alarm.
1 Press the [TIMER] button repeatedly
to select timer 1, 2, 3, or 4.
2 Use the [ ] / [ ] buttons to
select “Timer On” or “Timer Off”.
The timer numbers, which set “Timer On”
light up. After a few moments, the previous
display reappears.
Checking Timer Settings
1 Press the [TIMER] button repeatedly
to select timer 1, 2, 3, or 4, and then
press [ENTER].
2 Press [ENTER] repeatedly to see all
of the timer’s settings.
Notes:
• You can change the settings by using
the [ ] / [ ] buttons.
• If you change the settings of a timer
that is off, that timer will be turned on.
After confirming all the settings, the
previous display reappears.
To return to the previous display at any
point in this procedure, press the [MENU /
CLEAR] button.
Using the Sleep Timer
With the sleep timer, you can set the CD receiver so
that it automatically turns off after a specified period.
Press the [SLEEP] button repeatedly
to select the required sleep time.
With the [SLEEP] button, you can set the
sleep time from 90 to 10 minutes in 10
minute decrements.
Use the [ ] / [ ] buttons to set the
sleep time in 1 minute increments from 99
to 1.
When the sleep timer has been set, the
SLEEP indicator appears on the display, as
shown. The sleep time appears on the
display for about 8 seconds, then the
previous display reappears.
Checking the Remaining Sleep Time
To check the remaining sleep time, press the
[SLEEP] button.
Note that if you press the [SLEEP] button while the
sleep time is being displayed, you’ll shorten the sleep
time by 10 minutes.
Cancelling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until “Sleep Off” appears, then the SLEEP
indicator disappears.
SLEEP indicator