OTC Wireless 802.11 Wireless Serial Solutions WiSER2400.IP User Manual
Page 18
WiSER 2400 Technical Manual
Version 2.16
Copyright 2001-2005, OTC Wireless, Inc. All Rights Reserved
Page 18 of 32
3
3
.
.
U
U
s
s
i
i
n
n
g
g
t
t
h
h
e
e
W
W
i
i
S
S
E
E
R
R
2
2
4
4
0
0
0
0
A
A
d
d
m
m
i
i
n
n
i
i
s
s
t
t
r
r
a
a
t
t
i
i
o
o
n
n
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
3.1 Overview
This chapter describes the functionality and operations of the WiSER2400
Diagnostic and Configuration administrative software program. The
WiSER2400 administrative program is supported on Microsoft Windows®
98(SE), NT, Millennium, 2000, and XP.
To use the administrative program to monitor and configure the WiSER2400,
the PC can be connected to the WiSER2400 either directly through the serial
port by cable or via a wireless network connection.
A connection selection window will pop up as shown on the right when the
administrative program starts.
Once the connection selection is chosen, the administrative program will
display an interface as shown in Fig. 10 and Fig. 11 respectively, depending
on whether the PC is connected to the WiSER2400 by serial port, or by a
wireless connection.
Warning:
The administrative program in serial port connection
mode will not work if another RS232 application program is set to use
the same COM port. Make sure that no other application is connected
with the COM port when starting the administrative program. In
Windows, any connection with a COM port is exclusive.
3.1.1 The Tabs
There are five Tabs in the administrative software interface window:
Link Status
Configuration
Encryption
Statistics
Administration
Each will be covered in detail below.
Fig. 9
WiSER2400 administration connection dialog panel