Patching or – Oracle B32100-01 User Manual
Page 194
Patching OracleAS Guard Release 10.1.2.0.0 with Release 10.1.2.0.2
10-10
Oracle Application Server Installation Guide
upgrade procedure in Oracle Application Server High Availability Guide for more
information).
■
OracleAS Guard patch upgrade from OracleAS 10g (10.1.2.0.0) to OracleAS 10g
(10.1.2.0.2) (see
Section 10.5, "Patching OracleAS Guard Release 10.1.2.0.0 with
for more information).
If this is an upgrade installation of OracleAS Guard, make a copy of your dsa.conf
configuration file to save your current settings for your OracleAS Guard environment.
After running the OracleAS 10g (10.1.2.0.2) standalone install kit of OracleAS Guard,
you can restore your saved dsa.conf configuration file with your settings to continue
using the same settings for the upgraded OracleAS Guard environment.
To run the OracleAS 10g (10.1.2.0.2) standalone install kit of OracleAS Guard, run the
kit in the following directory path:
On UNIX systems:
/Disk2/asg/install/runInstaller
Choose the type of install that you want. Choose Typical for most installations. Choose
Custom or Reinstall
for upgrading from an older release of OracleAS Guard to the
current release.
Enter the ias_admin account password to continue the installation.
10.5 Patching OracleAS Guard Release 10.1.2.0.0 with Release 10.1.2.0.2
If you already have an OracleAS Disaster Recovery environment set up using
OracleAS Guard Release 10.1.2.0.0, you can patch OracleAS Guard in your
environment to take advantage of new features and support for the topologies
described in
Section 10.1, "OracleAS Disaster Recovery: Introduction"
. To patch your
OracleAS Disaster Recovery environment, follow these basic steps:
1.
Stop the OracleAS Guard server in all OracleAS 10.1.2.0.0 Oracle homes on both
production and standby sites using the following opmnctl command:
On UNIX systems:
<ORACLE_HOME>/opmn/bin/opmnctl stopall
2.
Install the OracleAS 10g (10.1.2.0.2) standalone install of OracleAS Guard into each
Oracle home on the production and standby sites.
If multiple Oracle homes exist on the same system, ensure that different ports are
configured for each of the OracleAS Guard servers in this configuration file.
Because this is an upgrade installation of OracleAS Guard, make a copy of your
dsa.conf
configuration file to save your current settings for your OracleAS
Guard environment. After running the OracleAS 10g (10.1.2.0.2) standalone install
kit of OracleAS Guard, you can restore your saved dsa.conf configuration file
with your settings to continue using the same settings for the upgraded OracleAS
Guard environment.
On UNIX systems:
<ORACLE_HOME>/dsa/dsa.conf
3.
Start the OracleAS Guard server in all OracleAS 10.1.2.0.0 Oracle homes on both
production and standby sites using the following opmnctl command:
On UNIX systems: