Onkyo TX-SR875 - Manual (Page 106)

106
Zone 2 and Zone 3 —Continued
Adjusting the Volume of Zones
Adjusting the Balance of Zones
Muting Zones
Adjusting the Tone of Zone 2
Notes:
• Zones can also be unmuted by adjusting the volume.
• The tone cannot be adjusted for Zone 3.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the Zone 2 Out
setting is set to Fixed (page 104).
• The Zone 3 level and balance functions have no effect
on the ZONE 3 PRE OUT when the Zone 3 Out set-
ting is set to Fixed (page 104).
On the remote controller, press
the [ZONE 2] or [ZONE 3]
REMOTE MODE button, and then
use the [LEVEL–] and [LEVEL+]
buttons.
On the AV receiver, press the
[ZONE 2] or [ZONE 3] button,
press the [LEVEL] button, and
then use the Up [
] and Down
[ ] buttons.
1 On the AV receiver, press the
[ZONE 2] or [ZONE 3] button.
2 Press the AV receiver’s [TONE]
button repeatedly to select Bal-
ance.
3 Use the Up [ ] and Down [ ]
buttons to adjust the balance.
You can adjust the balance from 0 in the
center to +10 dB to the right or +10 dB
to the left in 2 dB steps.
ZONE 3
ZONE 2
LEVEL LEVEL
AV receiver
Remote
controller
ZONE 2
ZONE 3
AV receiver
TONE
On the remote controller, press
the [ZONE 2] or [ZONE 3]
REMOTE MODE button, and then
press the [MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2] or
[ZONE 3] REMOTE MODE button,
and then press the [MUTING] but-
ton again.
1 On the AV receiver, press the
[ZONE 2] or [ZONE 3] button.
2 Press the AV receiver’s [TONE]
button repeatedly to select Bass
or Treble.
3 Use the Up [ ] and Down [ ]
buttons to adjust the bass or tre-
ble.
You can boost or cut the Bass or Treble
from –10 dB to +10 dB in 1 dB steps.
ZONE 3
ZONE 2
MUTING
ZONE 2
ZONE 3
AV receiver
TONE