Oricom TP110 - Manual (Page 7)

7
5.1 Making a call
1. Pick up the handset or press SPEAKER button (the speaker LED will
light) and wait for a dial tone.
2. Dial the number you wish to call. The display will show the number that
you are dialling. If you dial a number over 14 digits long, it will show the
last 14 digits only.
3. When you have completed your call, hang up the handset or press
SPEAKER button again to release the telephone line.
It is possible to switch from a handset to speakerphone conversation by
pressing the SPEAKER button and picking up or hanging up the handset
accordingly.
Pre Dialing a Call
1. Dial the number you wish to call . To correct a number press the DELETE
button for each incorrect digit.
2. Pick up the handset or press the SPEAKER button.
5.2 Receiving a Call
When you receive a call, the telephone rings, the Ringer LED flashes, and
the display shows the CALL # and the caller telephone number (with caller
ID service activated).
This feature allows you to decide to pick up the phone or not depending on
who is calling.
If you want to talk to the caller:
1. Pick up the handset or press SPEAKER button to answer the call.
2. At the end of the call, return the handset to the cradle or press SPEAKER
button again.
5.3 Redial function
If a number that you have dialled is engaged or you were unable to get
through to anybody. The last number dialled will be saved in the telephone
automatically. To use the redial facility, proceed as follows:
1. Lift the handset or press SPEAKER button .
2. Press the REDIAL button. The last saved redial number will now be dialled.
5.4 Pause
If needed for phone banking or behind a PBX system. You can insert a 3.6
seconds pause while dialing or storing a number into MEM. Press REDIAL
button at the desired point in number to insert a pause.
5.5 Recall and call waiting
The recall button timing can be switched between either 100ms (AUS) /
600ms (NZ), using the Recall switch located on the rear side of the handset.