Oricom TP110 - Manual (Page 8)

8
5.6 How To Turn on Telstra call waiting (Australia)
You can use the RECALL button to answer a second call while you are on
the phone. However this service will need to be turned on. For example to
turn on Telstra’s Call Waiting service:
1. Lift the handset and wait for dial tone then Press *43#.
2. You will hear the service message and then hang up.
Take two different calls at the same time
During a call, you will hear two loud beeps periodically to notify you of another
incoming call. If you wish to answer this call
1. Press Recall button listen for dial tone then Press 2 to put the current
call on hold and talk with the second caller.
2. Subsequent presses of Recall button listen for dial tone then Press 2
will toggle you between these 2 callers.
5.7 Call Timer
Immediately after dialling a telephone number a call timer will be shown on
the display. The timer is a simple way to help you keep track of how long the
call lasts.
5.8 Ringer Volume Control
The ringer sound level can be adjusted by sliding the RINGER switch. Select
high (HI) or soft (LO) sound level. When you don’t want to be disturbed, slide
the RINGER switch to the Off position.
The bright Red light (LED) on the base will flash with all incoming calls.
5.9 Volume Control
Speaker Volume Control
You can adjust the speaker volume level that suits you by sliding the VOLUME
switch.
Earpiece volume amplification control
The volume control enables you to adjust the earpiece volume on the handset.
Rotate the volume switch on the base to select a comfortable listening
level (1 lowest-9 loudest), the red LED will turm on.
WARNING
Setting the receiver volume to maximum may, under some situations
cause ear damage. We suggest returning the volume control to the
0
position after each call.