Olympus MAUSB-10 - Manual (Page 7)

7
How to install
Also refer to your computer’s user manual and the manuals for any optional devices you are using.
1 Turn on the computer
<98/98 SE/Me
ࡗInstall>
Turn on your computer’s power (and connected devices) to start Windows.
2 Install the device driver
<98/98 SE/Me
ࡗInstall>
When using the MAUSB-10 for the first time, you must first install the device driver included on the provided
CD-ROM.
Windows 98/98 SE/Me
1. Turn on the computer, then place the provided
CD-ROM into the computer’s CD-ROM drive.
2. When the CD-ROM is recognized, the
InstallShield setup window is displayed for a few
seconds. Then, the installation window appears
automatically.
3. Click the “Next” button.
* If the window at right does not appear, refer to
“If the installation window does not appear when
the CD-ROM is loaded” (
੬
p. 9).
* If you want to cancel the installation, click
“Cancel”.
[Note]
• Do NOT connect the MAUSB-10 to the com-
puter until installation of the device driver is
completed.
Before installation, make sure that the computer is turned on, then follow the steps below to install the driver
on your computer.
(* Note that the windows shown below may look different on your computer, depending on how your operating
system is configured.)
Do not connect to the computer before installation.