Oricom WNS1 - Manual (Page 9)

ALARM AND CLOCK FUNCTION
- 7 -
RINGER ON/OFF SWITCH (A+T / OFF / T)
HOW TO USE WITH YOUR TELEPHONE
DIMMER SWITCH ( )
Adjust the brightness of the display by moving the
control at the rear of your WNS1.
VOLUME CONTROL
Use this to set the volume of the ringer and the alarm
sound.
A+T (alarm + telephone): for the alarm and
telephone ring position.
OFF: alarm and ring off.
T (telephone): for the telephone ring position.
Ensure that your telephone is connected to the
WNS1 as shown in the installation section.
Select the ringer On/Off switch on the A+T or T
position for the ring.
Choose which of the alarm modes you wish to
alert you of your incoming telephone calls (see
page 5: V, V+S, S+F or F+V)
When the alarm mode selected indicates there is
an incoming telephone call, lift the telephone
handset and answer the call. When you have
finished the call replace the handset and the
alarm will be ready to indicate the next call.
-
-
-
-
-
-
-