OTC Wireless WiSER2400 - Manual (Page 12)

Figure 3. Radio Status Panels (AP: left; Station: right)
The modes switch automatically depending on the role of the WiSER2400 radio
unit connected to the COM port. When the radio unit acts as an AP, the radio
status panel is shown in AP mode. Likewise, when the radio unit acts as a
station, the radio statue panel is shown in STA mode. To retrieve or update the
Radio Status Panel, click Refresh button at the button of the main window.
In general, the Radio Status Panel of both modes displays the firmware version,
firmware release date, role, and communication channel used by the radios. In
AP mode, the panel displays additional information such as Beacon interval. In
station mode, the panel displays additional radio signal information such as the
Port Status, Link Quality, and Signal strength.
Configuration Panel
The Configuration panel is used to display MAC addresses, role of the radio
unit, the radio channel in use. The Configuration panel has AP mode and station
mode shown in Figure 4.
Figure 4. Configuration Panel
NOTE: The firmware is embedded with the “Auto Channel Scan” feature. This
means the Access Point automatically detects in-use channels and selects the
one that is not in-use. Therefore, users cannot manually change the channel
number.
To retrieve the configuration setting of the connected WiSER2400 radio unit, click
Refresh button located at the bottom of on the utility main window. If the settings
are retrieved successfully, the information such as MAC addresses and the
9