Onkyo TX SR805 - Manual (Page 102)

102
Zone 2 and Zone 3 —Continued
Zone 2 Video Output (TX-SR875 only)
The TX-SR875 features a composite video output for
connection to a TV in Zone 2, so you can enjoy both
audio and video in that zone.
Hookup
• Use a composite video cable to connect the AV
receiver’s ZONE 2 OUT V jack to a composite video
input on your Zone 2 TV.
Note:
• The ZONE 2 OUT V jack outputs video from compo-
nents connected to composite video inputs and
S-Video inputs.
Zone 2 12V Trigger
When Zone 2 is turned on, the output from the ZONE 2
12V TRIGGER OUT goes high (+12 volts, 100 milliam-
peres max). Connecting this jack to a 12-volt trigger
input on a component in Zone 2 will make that compo-
nent turn on or off as and when Zone 2 is turned on or off
on the AV receiver.
Zone 3 speakers must be connected to an amp in Zone 3.
Connecting Your Zone 3 Speakers
You can enjoy 2-channel stereo playback in Zone 3 and
a different source to those selected for your main room
and Zone 2.
Hookup
• Use an RCA audio cable to connect the AV receiver’s
ZONE 3 PRE OUT L/R jacks to an analog audio input
on your Zone 3 amp.
• Connect your Zone 3 speakers to the speaker termi-
nals on your Zone 3 amp.
Note:
• With the default settings, the Zone 3 volume must be
set on the Zone 3 amp. If your Zone 3 amp has no vol-
ume control, set the Zone 3 Out setting to Variable so
that you can set the Zone 3 volume on the AV receiver
(see page 104).
ZONE 2
OUT
Main room
TV
Zone 2
AV receiver
TV
Connecting Zone 3
ZONE 2 ZONE 3
PRE OUT
L
R
R L
IN
Main room
Zone 3
TV
Receiver/
integrated amp
AV receiver