Onkyo TX SR805 - Manual (Page 108)

108
Controlling Other Components
You can control your other components, including those
made by other manufacturers, with the remote controller.
This section explains how to:
• Enter the remote control code for a component that
you want to control: DVD, TV, VCR, etc.
• Learn commands directly from another component’s
remote controller (see page 111).
• Program the MACRO buttons to perform a sequence
of up to eight remote control actions (see page 112).
To control another component, you must first enter that
component’s remote control code to a REMOTE MODE
button. You’ll need to enter a code for each component
that you want to control.
Notes:
• Remote control codes cannot be entered for the
[RECEIVER] and [DOCK] REMOTE MODE but-
tons.
• The remote control codes provided are correct at the
time of printing but subject to change.
Entering Remote Control Codes
1 Look up the component’s remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
INPUT SELECTOR
LISTENING MODE
ON STANDBY
DISPLAY MUTING
RC- 690 M
GU IDE EXI T
PREV
CH
DIMMER
CDR/MD
SAT TAPE/AMP
SLEEP
MACRO
REMOTE MODE
SUBTITLE AUDIO REPEAT PLAY MODE
--/--- 10 11 12
VIDEO OFF OPEN/CLOSE
TV
TV CH
TV VOL
PLAYLIST RANDOM
DVD
AUX 1 AUX 2 GAME/TV
CBL/SAT VCR/DVR
D. TUN
CD TUNER TAPE
PHONO
VCR VCR DVD DVD HDD HDD
REC
ENTER
TEST TONE
AUDIO SEL
CH SEL
SURR
DIRECT THX PURE A
STEREO
LEVEL+ LEVEL-
L NIGHT
ALL ST
TO P M ENU MEN U
VOL
CH
DISC
ALBUM
TV
VCR
CABLE DOCK
DVD
RECEIVER
CD
+
-
1 2 3 ZONE 3
ZONE 2
INPUT
+
-
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
SE TUP RET UR N
Re-EQ
REMOTE
MODE
TV
RECEIVER
STANDBY
I
Number
buttons
Remote
indicator
2 While holding down the REMOTE
MODE button to which you want
to enter the code, press the
[STANDBY] button.
The Remote indicator lights up.
3 Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The Remote indicator flashes twice.
4 Press the REMOTE MODE button
again to select the remote con-
troller mode, point the remote
controller at the component, and
check the operation.
If the remote controller doesn’t work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.
CDR/MD
SAT
REMOTE MODE
TV
VCR
CABLE
DVD
CD
STANDBY
DVD
AUX 1 AUX 2 GAME/TV
CBL/SAT VCR/DVR
CD TUNER TAPE
0
1 2 3
4 5 6
7 8 9
• The DOCK remote mode can only be used with
the Onkyo RI Dock at this time.
• The [DVD] and [CD] REMOTE MODE buttons
are preprogrammed for use with Onkyo DVD
players and CD players, respectively.
• To control another manufacturer’s CD recorder or
MD recorder, enter the appropriate remote control
code to the [CD] REMOTE MODE button.