Onkyo TX-SR601E - Manual (Page 37)

37
Listening to Radio Broadcasts
STANDBY/ON
PHONES VIDEO 4 INPUT
DIGITAL
VIDEO 3 TAPE VIDEO 4
SURROUND THX DSP STEREO
STANDBY
DISPLAY
VIDEO 2 DVD VIDEO 1 AUDIO SELECTOR
LISTENING MODE
MASTER VOLUME RETURN
ENTER
AUDIO ADJUST SETUP
RT/PTY/TP
VCR 2 VCR 1 S VIDEO VIDEO AUDIO L R
OFF ON
POWER
TUNER CD PHONO DIRECT/ PURE AUDIO
PURE AUDIO
REC OUT ZONE 2 OFF LEVEL MEMORY
CLEAR
FM MODE
PRESET
TUNI NG
FM MODE
TUNER
TUNING /
One of the features of the TX-SR701/701E/601/601E that is most
frequently used is its ability to play FM and AM broadcast radio
stations. The TX-SR701/701E/601/601E provides a number of
listening modes perfect for listening to the radio and getting the
most out of your audio system. Also, by presetting radio stations
that you listen to frequently, you can select them easily by pressing
the CH
button on the remote controller.
1. Press the TUNER input source button.
Each time you press the TUNER button, the
input source changes between AM and FM.
2. Using the TUNING and buttons
on the front panel, tune into the
station you desire.
• The tuner frequency changes in 100-kHz (or 50-kHz)
increments for FM and 10-kHz (or 9-kHz) increments for
AM.
• You can press the TUNING or button continuously for
more than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
After you release the button and a station is received in
stereo, the scanning stops.
• The European model allows you to receive RDS broadcasts.
See page 39 for more information regarding tuning into
RDS broadcasts.
Tuning into a radio station
TUNER
PRESET
TUNI NG
“FM STEREO”
(Lights red)
Tuned in stereo Auto mode
Band Frequency
When you tune into a radio station, TUNED
indicator appears in the display. If you tune
into an FM station in stereo, then “FM
STEREO” appears. If the signal is weak, it
may be impossible to tune into the station in
stereo. In such a case, press the FM MODE
button on the front panel. The AUTO
indication disappears and the radio station is
output in the monaural mode. To return to
stereo, press the FM MODE button again.
“AUTO” appears. Some inter-station noise
may be heard, but the sound will not cut in and
out as it would if stereo was selected.
Listening to a stereo radio station (FM mode)