Onkyo TX-SR601E - Manual (Page 21)

21
Connections
9. Connecting video camera, etc. (VIDEO 4 INPUT)
Using an RCA video cable, connect the video output jack
(composite) of the device to the VIDEO 4 VIDEO jack of the TX-
SR701/701E/601/601E. Or if the device has an S video output jack,
connect it to the VIDEO 4 S VIDEO jack of the TX-SR701/701E/
601/601E using an S video cable.
Using an RCA audio cable, connect the audio output jack of the
device to the VIDEO 4 AUDIO jacks of the TX-SR701/701E/601/
601E. Make sure that you properly connect the left channel to the L
jack and the right channel to the R jack.
If the device has an optical digital output, connect it to the VIDEO 4
DIGITAL jack of the TX-SR701/701E/601/601E.
The VIDEO 4 digital input is fixed to the OPTICAL input on
the front panel.
When the TX-SR701/701E/601/601E is in the ZONE 2 mode, this
terminal outputs at 12 V/100 mA.
12V TRIGGER ZONE 2 terminal
S Video output
Digital output
(optical)
9. Video camera/ Video game
(VIDEO 4 INPUT)
Video output
Analog output
R (red)
L (white)
These jacks are for connecting an auxiliary power amplifier.
You can use an auxiliary power amplifiers to listen at louder
volumes than you can with the TX-SR701/701E alone. When using
a power amplifier, connect each speaker to the power amplifier.
Note:
If you use a power amplifier connected to the SURR BACK PRE
OUT terminal and connect two surround back speakers to the
amplifier, set the “Hardware Config”
→ “b. Surr Back” setting to
“2ch (PRE OUT)” (see page 55).
PRE OUT (TX-SR701/701E only)
SUR
BAC
SPE
FRONT SURR CENTER SURR BACK
(SB)
ZONE 2
SUB
WOOFER
PRE OUT
R
L
R
L
6 5 2 1 4 3 8 7
1. Front right speaker
2. Front left speaker
3. Surround right
speaker
4. Surround left speaker
5. Subwoofer
6. Center speaker
7. Surround back right
speaker
8. Surround back left speaker
L (white) R (red)
Power amplifier
R (red) L (white) L (white) R (red)
Subw
oof
er
Surr
ound
Fr
ont
Center Surr
ound bac
k