Display your lcd tv using a wall bracket:” on, Choosing a location for your lcd tv, Warning – OxiBrands Integrated High Definition LCD Television 40E220U User Manual

Page 5

Advertising
background image

5

5.375 x 8.375 ver 2.3

38) During a lightning storm, do not touch the

connecting cables or product.

39) For added protection of your TV from lightning and

power surges, always unplug the power cord and

disconnect the antenna from the TV if you leave

the TV unattended or unused for long periods of

time.

40) Always unplug the TV to completely disconnect

from mains power. When the TV is turned off using

the on/off switch, it is not completely disconnected

from power and a minute amount of current is still

consumed.

41) During normal use, the TV may make occasional

snapping or popping sounds. This is normal,

especially when the unit is being turned on or off. If

these sounds become frequent or continuous,

unplug the power cord and contact a Toshiba

Authorized Service Provider.

42)

Never strike the screen with a sharp or heavy

object.

43) • The LCD screen of this product can be damaged

by ultraviolet radiation from the sun. When

selecting a location for the television, avoid

locations where the screen may be exposed to

direct sunlight, such as in front of a window.

• Never touch, press, or place anything on the

LCD screen. These actions will damage the LCD

screen. If you need to clean the LCD screen,

follow the instructions in item

36)

, on page 4.

Service

44)

WARNING

:

RISK OF ELECTRIC SHOCK!

Never attempt to service the TV yourself. Opening

and removing the covers may expose you to

dangerous voltage or other hazards. Failure to

follow this WARNING may result in death or

serious injury. Refer all servicing not specified in

this manual to a Toshiba Authorized Service

Provider.

45) If you have the TV serviced:

• Ask the service technician to use only

replacement parts specified by the

manufacturer.

• Upon completion of service, ask the service

technician to perform routine safety checks to

determine that the TV is in safe operating

condition.

46) The cold cathode fluorescent lamp inside the LCD

panel contains a small amount of mercury. When

the TV reaches the end of its useful life, dispose of

the used TV by the approved method for your

area, or ask a qualified service technician to

properly dispose of the TV.

Note: The lamp(s) inside this product
contain mercury. Disposal may be
regulated due to environmental

considerations. For disposal or recycling
information, contact your local authorities or the
Electronics Industries Alliance (www.eiae.org).

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal
Stand:

Observe the following safety precautions:
1) Read and follow the pedestal assembly

instructions included with the pedestal.
CAUTION: Before beginning pedestal assembly,

carefully lay the front of the LCD Panel face down

on a flat, cushioned surface such as a quilt or

blanket. Leave the bottom of the unit protruding

over the edge of the surface and assemble the

pedestal as indicated below.
Note: Extreme care should always be used when

attaching the pedestal stand to avoid damage to

the LCD panel.

2) Place the TV on a sturdy, level surface that can

support the weight of the TV.

3) Be sure to secure the TV to a wall stud, pillar,

surface, or other immovable structure. See item

26)

page 4.

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a

wall bracket Listed by an independent laboratory

(such as UL, CSA, ETL) that is appropriate for the size

and weight of the TV (see page 2):
1) CAUTION: Two people are required for

installation.

2) Unplug and remove any cables and/or other

component connectors from the rear of the TV.

3) Remove the screws of the VESA Mounting Pattern

show in the table on the next page.
CAUTION: Do not use the screws removed from

the back cover to attach the wall mount bracket to

the TV.

4) Always use the screws supplied or recommended

by the wall mount manufacturer.

5) Follow the instructions provided with your wall

bracket. Before proceeding, make sure the

appropriate bracket(s) are attached to the wall and

the back of the TV as described in the instructions

provided with the wall bracket.

6) After attaching the appropriate bracket(s) to the

wall and the back of the TV, remove the pedestal

stand from the TV, as described on page 6.

WARNING: RISK OF SERIOUS

PERSONAL INJURY OR

EQUIPMENT DAMAGE!

Advertising
This manual is related to the following products: