Oricom W1 - Manual (Page 11)

11
The call timer will be displayed a short while after your call is connected.
It shows the duration of the call. This timer is shown in minutes and
seconds (MM-SS) in the first hour. After that, it will be shown in hours
and minutes (HH-MM) with the “-“blinking to indicate the seconds.
When you end a call, the timer will be displayed for 5 more seconds
before the screen returns to the handset label.
Adjusting the volume
Press e or f to adjust the receiver volume. The display shows the
volume level of high “ooo”, medium “oo” or low “o”.
Muting the call
1. Press MUTE to mute the call. turns on. The caller would not
be able to hear you but you would still be able to hear the caller.
2. Press MUTE again to unmute the call.
Chain dialling
You can dial out numbers from the phonebook even after you have
seized the phone line. And there is no limit to the number of times chain
dialing is accessed.
1. Press
. turns on.
2. Press e or f to scroll through the phonebook records. Or you
can use the number keys to jump directly to the record starting with
the corresponding letters of that key. If you decide to quit using
chain dialing, simply press
to exit.
3. Press OK to dial out the number.
Call waiting
You can use the recall function to answer a second call while you are on
the phone. However this service will need to be turned on. For example
to turn on Telstra’s Call Waiting service:
1. Press wait for dial tone then Press *43#
2. You will hear a service tone then Press .
Taking two calls at the same time
If you have subscribed to your telephone network operators Call Waiting
Caller ID service, your phone will display the number of the second
incoming call for around 60 seconds while you are talking on the phone.