Oricom W1 User Manual
Page 9
9
charge. This is normal. A handset reaching a very low battery voltage
level will go into sleep mode, displaying LOW BATT on the screen.
It is good practice to replace the handset on the base unit to charge
when it is not in use to ensure the handset is always fully charged.
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. Refer to the original type supplied with this phone.
Ni-MH rechargeable batteries must be disposed of in accordance with
applicable waste disposal regulations.
BASIC OPERATIONS
During standby
When the phone is in standby, the LCD displays the handset label. The
handset number related to the connected base will also be displayed
right justified. The battery icon reflects the current battery level and the
signal icon indicates the handset is linked to the base.
Answering an incoming external call
When there is an incoming call, the phone rings and
flashes. If a CID
record is received, the caller information is displayed.
turns on if the phone number contains more than 12 digits. In this
case, only the last 12 digits are displayed.
If you press
when the phone is ringing, the handset ringer will be
turned off for this incoming call.
1. Press
to answer the call.
turns on.
2. Call timer is displayed 10 seconds after the call is connected
3. Press
or place the handset on the base cradle to disconnect.
ORICOM 1
JOHN