Onkyo MB-S1 - Manual (Page 48)

47
3. Turn on the MB-S1.
4. Insert the supplied CD-ROM to the PC's
CD-ROM drive.
5. Follow the instructions on the display to
install the device driver.
• The device drivers are loaded in the following order: “MB-S1/
HDR-1 Driver” and “MB-S1/HDR-1 Export Driver.”
• When the MB-S1 is successfully recognized on the PC,
“UE205DRV Device” appears.
6. When the device drivers are
successfully recognized on the PC, the
install process finishes.
Installing the device driver
1. Turn on the PC.
Make sure the operating system starts and runs.
2. Connect the MB-S1 to the PC using a
USB cable.
Setting the PC
When connecting the MB-S1 to PC first time, you need to install the device driver.
Notes
• In usual, the device drivers are automatically installed using the
steps 1 and 2 in “Installing the device driver.”
If “All New Hardware Wizard” screen does not appear,
without disconnecting the USB cable, do the following.
1 Right-click My Computer and select Properties.
2 Click the Device Manager tab.
3 Click Update.
“All New Hardware Wizard” screen appears. Then follow the
instructions on the display to install the device driver.
• When you connect the USB cable to another USB connector on
the same PC, certain version of Windows 98 may require re-
installing the device driver. In this case, click Cancel button and
connect the USB cable to the one you connected when installing
the device driver. Or re-install the device driver again following
the instructions on the display.
“Add New Hardware Wizard” appears in the PC's display.
ON
STANDBY
USB
STANDBY / ON
DISPLAY
Connect the flat side of the USB cable to the USB
connector on PC and the other side of the USB cable to
the USB connector on the front panel of the MB-S1.
MB-S1
USB cable
Flat side.