Onkyo CR-325 - Manual (Page 25)

25
Basic Operations
To turn on the CD receiver, press the [STANDBY/ON]
button on the CD receiver or remote controller. The
STANDBY indicator goes off.
Press the [STANDBY/ON] button again to set the CD
receiver to Standby. The STANDBY indicator lights up.
Tip:
When you start playback on (or turn on) an Onkyo RI
Dock, MD recorder, or cassette deck that’s connected to
the CD receiver with an
cable and analog audio
cable, the CD receiver turns on automatically. Similarly,
when you set the CD receiver to On or Standby, the other
component will also be set to On or Standby.
Turn the [VOLUME] control clockwise to increase the
volume or counterclockwise to decrease it.
You can also use remote controller’s VOLUME [ ]/[ ]
buttons.
You can select CD, AM, FM, or a connected component
(TAPE, DOCK, USB) as the input source.
To select the input source, press the remote controller’s
INPUT [
]/[ ] buttons repeatedly. On the CD
receiver, press the [INPUT] button repeatedly. The input
sources are selected in the following order.
* Input Display can be changed (see page 27).
Turn down the volume, then connect your stereo head-
phones to the PHONES minijack.
You can adjust the volume and mute the sound, as
explained earlier.
The speakers output no sound while the headphones are
connected.
VOLUME
/
STANDBY/ON
INPUT
/
VOLUME STANDBY/ON
INPUT PHONES
STANDBY indicator
Turning On the CD receiver
Adjusting the Volume
Remote
controller
CD receiver
Remote
controller
CD receiver
Selecting the Input Source
Using Headphones
CD FM
TAPE USB DOCK
*
CD FM AM
DOCK TAPE
AM
*
• CR-525
• CR-325
PHONES jack