Onkyo TX-NR3008 - Manual (Page 80)

80
En
Multi Zone
In addition to your main listening room, you can also enjoy playback in the other room, or as we call Multi Zone. And,
you can select a different source for each room.
There are two ways you can connect Zone 2 speakers:
1. Connect them directly to the AV receiver.
2. Connect them to an amp in Zone 2.
Connecting Your Zone 2 Speakers Directly
to the AV receiver
This setup allows 7.2-channel playback in your main room
and 2-channel stereo playback in Zone 2, with a different
source in each room. This is called Powered Zone 2, as the
Zone 2 speakers are powered by the AV receiver. Note that
when Powered Zone 2 is turned off, you can enjoy 9.2-
channel playback in your main room.
Note
• With this setup, the Zone 2 volume is controlled by the AV
receiver.
• Powered Zone 2 cannot be used if “Speakers Type(Front B)” is
set to “Normal”, “Bi-Amp” or “BTL” ( ➔ 51).
• This setting cannot be used if “Front High + Front Wide” set-
ting is set to “Yes”.
Connecting Your Zone 2 Speakers to an
Amp in Zone 2
This setup allows 9.2-channel playback in your main lis-
tening room and 2-channel stereo playback in Zone 2,
with a different source in each room.
Note
• With the default settings, the Zone 2 volume must be set on the
Zone 2 amp. If your Zone 2 amp has no volume control, set the
“Zone 2 Out” setting to “Variable” so that you can set the
Zone 2 volume on the AV receiver (
➔ 83).
Connecting Zone 2
To use this setup, you must set the “Powered Zone 2”
setting to “Act” (
➔ 82).
Hookup
• Connect your Zone 2 speakers to the AV receiver’s FRONT
WIDE/ZONE 2 L/R terminals.
R L
Main room
Zone 2
TV
AV receiver
Hookup
• Use an RCA audio cable to connect the AV receiver’s
ZONE 2 PRE OUT L/R jacks to an analog audio input on
your Zone 2 amp.
• Connect your Zone 2 speakers to the speaker terminals on
your Zone 2 amp.
R L
IN
Main room
TV
Zone 2
AV receiver
Receiver/
integrated amp