Oregon Vertical/Horizontal 22 Ton Log Splitter S402022H0/S402022K0 - Manual (Page 7)

MAINTENANCE & SAFETY
The hydraulic system of your log splitter requires careful inspection along with the mechanical parts. Be sure to
replace frayed, kinked, cracked or otherwise damaged hydraulic hoses or hydraulic components.
NEVER check for leaks of hydraulic fluid with your hand. Fluid escaping from a small hole can be almost invisible.
Escaping fluid under pressure can have sufficient force to penetrate skin causing SERIOUS INJURY or even DEATH.
Leaks can be safely detected by passing a piece of cardboard over the suspected leak and looking for discoloration.
NEVER remove the cap from the hydraulic tank or reservoir while the log splitter is running. The tank could contain hot
oil under pressure which could result in serious injury.
NEVER adjust the hydraulic valve. The pressure relief valve on your log splitter is preset at the factory. Only a qualified
service technician should perform this adjustment.
ALWAYS seek professional medical attention immediately if injured by escaping hydraulic fluid. Serious infection or
reaction can develop if proper medical treatment is not administered immediately.
ALWAYS be sure to relieve all pressure by shutting off the engine and moving the valve control handle back and forth
should it become necessary to loosen or remove any hydraulic fitting.
FIRE PREVENTION
NEVER operate your log splitter near a flame or spark or smoke during operation. Hydraulic oil and gasoline are
flammable and can explode.
NEVER fill the gas tank while the engine is hot or running. Allow the engine to cool before refueling.
ONLY refuel your log splitter in a clear area with no gas fumes or spilled gas.
ALWAYS replace the gas cap securely.
If gasoline has spilled, move the log splitter away from the area of the spill and avoid creating any source of ignition until
the spilled gas has evaporated.
ALWAYS drain the fuel tank prior to storage to avoid the potential fire hazard.
ALWAYS store gasoline in an approved, tightly sealed container and away from heating appliances. Store the container in
a cool, dry place.
Page 5
NEVER perform any service or repair on your log splitter without first removing the spark plug wire.
ALWAYS perform all recommended maintenance procedures before using your log splitter.
ALWAYS check the level of hydraulic oil and engine oil before operation.
ALWAYS periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.
ALWAYS replace all damaged or worn parts immediately.
ALWAYS be sure that all replacement parts meet manufacturer’s specifications.