Onkyo AV Receiver TX-NR818 - Manual (Page 84)

Controlling Other Components
En-84
Controlling Other
Components
You can use the AV receiver’s remote controller to control
your other AV components. This section explains how to
enter the remote control code for a component that you
want to control: DVD, TV, CD, etc.
See “Learning Commands” for learning commands
directly from another component’s remote controller
(
➔ page 89 ).
See “Using Normal Macros” for programming
ACTIVITIES to perform a sequence of remote control
actions (
➔ page 90 ).
The following REMOTE MODE buttons are
preprogrammed with remote control codes for controlling
the components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
indicated pages.
You can look up for an appropriate remote control code
from the on-screen menu.
Preprogrammed Remote Control
Codes
BD/DVD Onkyo Blu-ray Disc player ( ➔ page 87 )
TV/CD Onkyo CD player ( ➔ page 86 )
STB/DVR Apple TV
Looking up for Remote Control Codes
You need to connect your TV to the HDMI output
(
HDMI OUT MAIN) to make the following on-screen
setting.
1 Press RECEIVER followed by HOME.
2 Use / to select “Setup”, and then press ENTER.
3 Use / to select “Remote Controller Setup”, and
then press
ENTER.
4 Use / to select “Remote Mode Setup”, and then
press
ENTER.
5 Use / to select a remote mode, and then press
ENTER.
The menu of category selection appears.
6 Use / to select a category, and then press
ENTER.
The keyboard screen for brand name input appears.
7 Use / / / to select a character, and then press
ENTER.
Repeat this step for the first three characters of the
brand name.
When you have entered the 3rd character, select
“Search” and press ENTER.
A list of brand names is retrieved.
If the desired brand name is not found:
Use to select “Not Listed”, and then press
ENTER.
The keyboard screen for brand name input appears.
8 Use / to select a brand, and then press ENTER.
A remote control code with its instructions are
displayed. Follow the procedure.
9 If you can control the component, use / to select
“OK”, and then press
ENTER.
The on-screen menu returns to the “Remote Mode
Setup” front screen.
If you cannot control the component, use / to
select “Try Next Code” and press
ENTER.
The next code is displayed.