One Stop Gardens 98197 - Manual (Page 5)

Page 5 SKU 98197 for technical questions, please call 1-800-444-3353.
place by sliding on Flat Washer (54)
and Hex Lock Nut (18)-see Figure 2.
Hex Bolt (68)
Brace Rod
Clip (70)
Hex Bolt (73)
Sweeper
Housing
(65)
Brace
Rod (7)
Hitch
Bracket (47)
Tongue
Bracket (89)
figure 3
4. Before assembling the Hitch Bracket
to the Hitch Tongue, see section on
determining position for your towing
vehicle on page 8.
Note: Placement of the Hitch Bracket
5.
(47) will be determined by your tow-
ing vehicle. Connect the Hitch Brack-
et to the Hitch Tongue with Hex Bolt
(68), through Brace Rod Clip (70),
onto Brace Rod (7) and down through
middle hole in the Hitch Bracket (47).
Continue through Hitch Tongue (65),
Tongue Bracket (89) and thread on
Hex Lock Nut (60)-see Figure 3 and
assembly diagram.
Insert Hex Bolt (73) down through the
6.
rear hole of the Hitch Bracket (47),
down through the Hitch Tongue (65)
and secure with Hex Lock Nut (60)-
see Figure 3.
Tighten down all hardware.
7.
Height Adjust
Handle (69)
Hex Lock
Nut (18)
Washer
(86)
Curved Head
Bolt (37)
Grip (45)
figure 4
8. Place on Height Adjustment Handle
(69) the Height Adjustment Tube (27).
Insert the Curved Head Bolt (37) up
through the Height Adjustment Tube
(27). Slide on Washer (86), and se-
cure with Lock Nut (18). Repeat for
second hole-see Figure 4.
Slide Grip (45) onto Height Adjust-
9.
ment Handle (69) so that the inden-
tations for fingers face as shown in
Figure 4.
Height Adjustment
Strap (6)
Bolt (56)
Bolt (29)
Lock Washer
(44)
Hex Nut 5/16”
(28)
Angle
Bracket (38)
Tongue
Bracket (89)
Bolt (71)
Washer (54)
figure 5
Grip (45)
Bushing
Spacer (30)
10. Attach the Angle Bracket (38) to the
Hitch Tongue (65) as shown. Secure