One Stop Gardens 98197 - Manual (Page 7)

Page 7 SKU 98197 for technical questions, please call 1-800-444-3353.
Head Bolt (63)
and Lock Nut
(80)
Lower Hopper
Tubes (10/11)
figure 8
3. Attach the two Lower Hopper Tubes
as shown in Figure 8. Secure in
place with Curved Head Bolt (63) and
Hex Lock Nut (80) as shown in as-
sembly diagram.
Set the assembled Lower Hopper
4.
Tubes (10/11) onto the bottom of the
Hopper Bag (12).
Secure the Upper and Lower Hop-
5.
per Tube ends together with two Hex
Bolts (61) and Hex Lock Nut (57). Do
not overtighten.
Assemble the Bag Frame Stamp (49)
6.
and Skirt Retainer (43) to the front
edge of the bag bottom. Set the Skirt
Retainer (43) on top and the Frame
Strap (49). Secure with six Screws
(52) and Lock Nuts (53).
Attach the Bag Frame Strap (49) to
7.
the lower hopper frame. Secure with
Hex Bolt (61) and Lock Nut (57).
Set the bag corners over the lower
8.
hopper tube. Snap the bag bottoms
closed with snaps on bag.
Note: Hopper Support Rods are steel
9.
and require force to bend or bow. Ex-
cercise caution and do not over bend
as this will cause a loss of necessary
tension. Set each of the two Hopper
Support Rods (50) by placing the top
end of each rod into the hole in the
Upper tube. Bend the Hopper Sup-
port Rod outward and snap the bot-
tom end of the Hopper Support Rod
(50) into the hole in the Lower Hop-
per Tube (11).
Locate the hole along the side of
10.
the Upper Hopper Tubes. Align the
Hopper Bag (12) with the hole in the
Upper Hopper Tube. Pierce a hole
through the Hopper Bag at the point
it is aligned with the Upper Hopper
Tube.
Clevis Pin (58)
L
ock Nut (55)
Bolt (56)
Mount
Clamp (64)
Bag Retainer
Clevis (66)
Cotter
Pin (62)
figure 9
11. Secure the Mount Clamps (64) to
each side of the Upper Hopper
Tubes (9). Place one Clevis Pin (58)
through the Mount Clamps (64), the
Hopper Bag and the Upper Hopper
Tubes (9). Secure with Hex Bolts
(56) and Lock Nuts (55)-see Figure
9. Repeat for second side.
Secure the Bag Retainers with Clevis
12.
Pins (58) and Cotter Pin (62). Wrap
Cotter Pin around Clevis Pin as
shown in Figure 9.
Secure the Rope (78) to the top cen-
13.
ter of the Hopper Bag Frame.
Secure the Wind Screen (31) to the
14.
Upper Hopper Tube (9). Stretch out
all four corner loops and snap into