One for All URC-9910 - Manual (Page 20)

Programming Volume Unlock
1. On the URC-9910 remote control, press and hold
SET until you see the display change from the
current device and time to [CODE SET].
2. Press the ▼ key five times until you see the display
change to [VOL UNLOCK].
(x 5)
NOTE: If you go past [VOL UNLOCK], press the ▲ key one or
more times to return to it.
3. Press SELECT once to begin programming.You will
see the display change to [ALL MODE].
To unlock one mode, skip to step 4. Otherwise press
SELECT once to unlock all modes.You will see the
display change to [UNLOCKED] and then [EXIT SETUP]
as the remote control automatically exits the pro-
gramming mode and returns to normal operation.
4. (Optional) Press ▲ (or ▼ ) once.You will see the
display change to [ONE MODE].
or
a. Press SELECT once.You will see the display change
to [SEL MODE].
b. Press a mode key once (e.g., TV) to unlock it.
You will see the display change to [UNLOCKED]
and return to [SEL MODE].
c. If desired, repeat step 4b as needed to unlock
volume controls for other devices. Otherwise,
press EXIT to exit the programming mode.You
will see an [EXIT SETUP] message as the remote
control returns to normal operation.
SELECT
33
SELECT