One for All URC-9910 - Manual (Page 40)

Adding The IR Signal Extension Cord
Included with the URC-9910 remote control package is an IR Signal
Extension Cord for use with a home theater device that is not in
direct line-of-sight of the IR/RF Command Center.
If you are having problems remotely controlling a home theater
device from another room, try performing the following installation:
1. Plug the 4-foot IR Signal Extension Cord into the
back of the IR/RF Command Center.
2. Run the IR Signal Extension Cord to the device that is
not in line-of-sight of the IR/RF Command Center.
3. Using the supplied double-sided tape, attach the
IR Signal Extension Cord so that its LED is over or
next to the IR sensor of your home theater device.
LED
4. Test the installation by again taking the URC-9910
remote control into another room in your home, up
to 100 feet* away. Select a device key (e.g., TV) and
press it once. Then press POWER once.
The IR/RF Command Center will convert the RF sig-
nal from the URC-9910 remote control into an IR
signal and transmit that signal through the IR Signal
Extension Cord to turn on your device (e.g.,TV).
If it does not turn on, try repositioning the LED until
the device can be controlled, then re-attach the LED.
*Distance may vary
53