Oki B6250 - Manual (Page 15)

B6250 User’s Guide> 15
Power Saver Modes
This printer is equipped with a low power mode and a sleep mode to
reduce power consumption when it is left idle.
When no print data is received for 5 minutes, the printer will enter
the low power mode. When no data is received for a further 10
minutes (a total of 15 minutes lapse (default settings) since the last
received data), it will enter sleep mode. You can specify whether the
printer goes into low power mode or sleep mode. The time ranges to
specify for the printer to go into low power mode or sleep mode are
5 to 60 minutes respectively. Consumption of power during the sleep
mode is 10 W or less and the time required to exit from the sleep
mode to a print-ready status is about 10 seconds.
NOTE
> You can also enable either the low power mode or sleep
mode.
> Both low power mode and sleep mode cannot be disabled
at the same time.
> The sleep mode setting has precedence when both the low
power mode and sleep mode are enabled. For example,
when the sleep mode and low power mode time have
been set to 15 minutes and 45 minutes respectively, the
printer will go into sleep mode after no data has been
received for 15 minutes. It will continue to remain in sleep
mode and will not go into low power mode after a further
30 minutes.
Exiting the Power Saver Mode
The printer automatically cancels its power save status once it
receives data from the computer.
Cancelling/Checking Printing
Cancelling Printing
To cancel printing, you can either cancel the print job at this printer
or at the computer.
Cancelling a Print Job at the Printer