Omega Vehicle Security LDP63100 - Manual (Page 6)

6
2.0 INSTALLING THE DISPLAY
DISPLAY INSTALLATION
The LDP63100 display is intended to be
mounted into a panel or enclosure. The display is
provided with a gasket to provide a water-tight
seal. The recommended minimum panel thickness
for NEMA 4/IP65 sealing is 0.060" (1.57 mm).
For panel mounting, prepare the panel
cut-out to the dimensions shown in
Figure 3. The supplied template may be
used to mark the cut-out and hole
locations on the panel. After the panel
cut-out has been deburred, slide the
panel gasket over the rear of the display
and onto the mounting studs. Insert the
display into the panel cut-out as
illustrated in Figure 4. Install 14 # 10-32
keps nuts (supplied) and tighten evenly
for uniform gasket compression. Do not
over-tighten the nuts.
By using additional mounting accessories,
the LDP63100 can be surface-wall mounted,
suspended, or bottom mounted. Separate installation
instructions are provided with the mounting accessories.
Environment And Cleaning
The display should be installed in a location that does not exceed the maximum
operating temperature and provides good air circulation. Placing the system
near devices that generate excessive heat should be avoided.
The bezel should be cleaned only with a soft cloth and neutral
soap product. Do NOT use solvents. Continuous exposure to
direct sunlight may accelerate the aging process of the bezel.
Figure 4, Installing The LDP63100 Into A Panel
Figure 3, Panel Cut-out for the LDP63100
DIMENSIONS In inches (mm)