Omega Vehicle Security LDP63100 - Manual (Page 7)

7
Once assembled, the LDP63100 has all the same
functions and capabilities of our DP63500, DP63600, and
DP63700 Series Intelligent Panel Meters. Therefore, you
will find the appropriate meter information packed with
the LDP63100. Simply follow the instructions to wire
and program the display for your application.
Note: Both the LDP63100 and the input module
require power. It is recommended to connect the primary
AC power to the LDP63100 terminal block, then jumper
to the input module.
3.0 WIRING AND PROGRAMMING THE DISPLAY
LDP63100 TERMINAL BLOCK
RJ12 CONNECTOR ON BOTTOM OF UNIT
Rear Terminal Block
External normally open switches can be wired via the terminal block to allow
unit programming. A minimum of 3 switches would be required. Each
external switch must be wired between the key and the common terminal.
Optional Programming Remote (LDP6-PGM)
This optional programming remote plugs
into the LDP63100 through an RJ12
connector and a 10 foot cable. The
buttons on the programming box function
the same as the DP63500, DP63600, and
DP63700 meters. Simply program the
LDP63100 exactly as the meter
instructions indicate. The programming
box can be left connected to the
LDP63100 for future programming
changes or can be disconnected and used
to program additional LDP63100 units.
LDP63100 PROGRAMMING
The unit is a large display, designed to be remotely mounted. Therefore, the unit
does not have a programming keypad. Unit programming must be accomplished by
one of the following three methods: