Oricom AM100 User Manual

Page 12

Advertising
background image

11

6.2 Turning Your System On

If you forget to turn your system on, you can phone in from a
remote location and turn it on automatically.
1.

Call your telephone number.

2.

The system answers after 10 rings. After the beep, enter
your 3-digit security code.

3.

After the second beep, press 9# then hang up. Subsequent
messages will be recorded.

6.3 Remote Commands

If the correct code was accessed, you hear two beeps.
Option

Press

Play messages in mailbox 1

1 #

Play messages in mailbox 2

2 #

Delete all old messages

3 #

(all messages must be played back)

Record new outgoing message

7 #

(Press 7# again to stop recording outgoing message)

Turn system off/on

9 #

Monitor the room

0 #

When you press 1# to play messages in mailbox 1, or 2# to play
messages in mailbox 2 (during playback), you can then press
the following keys to get these remote functions.
Option

Press

Erase current message

3 #

Repeat previous message

6 #

Skip to next message

7 #

Repeat current message

8 #

Stop message playback

# #

After all your messages have been played, you hear two short
beeps. You have 20 seconds to access the menu again,
otherwise, the unit disconnects automatically.

Note: When you are in remote playback, if there are new
messages in mailbox 1 or mailbox 2, enter the instruction “1#”
or “2#”, only new messages will be played back to you; if there
are no new messages in mailbox 1 or mailbox 2, enter the
instruction “1#” or “2#”, all messages will be played back to you.

Advertising