Oricom AM100 - Manual (Page 6)

5
Notes:
•
During the day/time setting, the display will turn off.
• If there is a delay of 20 seconds between any of the steps,
the system exits day/time setup mode. When you have set
the AM/PM and then wait for 20 seconds, the unit will
automatically announce the current day of the week and
the time, and exits day/time setup mode.
• If you have not set the day and time and you press /
TIME CHECK button, the system announces “Time is not
set”.
• You must reset the clock after replacing the battery.
4.4 Setting the Number of Rings
Slide the ring select switch to 2 or 6 to select the number of
rings you hear before the system answers. Slide to TS (Toll Saver)
to avoid unnecessary charges when calling long distance to
check your messages. If there are new messages, the system
answers after two rings. Otherwise, the system answers after
six rings. If you hear more than two rings, you know you can
hang up because there are no new messages.
4.5 Recording the Outgoing Message
There are approximately 40 minutes of total recording time
shared by your outgoing message and incoming messages. You
can use the system’s prerecorded outgoing message, “Hello,
please leave your message after the beep”, or record your own.
1.
Hold down GREETING button until ‘0’ appears on the display
and the system beeps. Speak clearly towards the top of the
unit. The display will count from ‘0’ to ‘9’ until the recording
has stopped.
2. Release GREETING button when you are finished. The
system automatically plays back your recorded message.
During playback, “A” will appear on the display.