SUUNTO Vector HR - Manual (Page 48)

4
6.1 beaRIng TRaCkIng sub Mode
the user can select to change from the cardinal point mode to the bearing tracking mode (fig. 5).
In the compass main mode:
1. PRESS the [Select] button and hold in for 2 seconds. Located in Field 1, “OFF” will begin to flash (Fig. 53).
. press either the [+] or the [-] button to change the setting between “off” and “on”.
3. at the selection desired, press the [select] button to move to the next setting. located in field , the actual bearing in degrees
will begin to flash (Fig. 54).
4. turn the Wristop computer to the desired direction. lock the bearing displayed by pressing the [-] button.
5. adjust the locked bearing, if necessary by pressing the [select] button and then adjusting the value with the [+] and [-] buttons.
6. at the desired bearing to track, press the [mode] button to accept the changes and exit the setup program.
note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit setup.
note: locking in the Bearing tracking sub mode blocks the compass reading.
6.2 deClInaTIon adjusTMenT sub Mode
the Wristop computer allows the user to compensate the difference between true north and magnetic north. this process is accomplished
by adjusting the declination, resulting in the user obtaining correct compass readings.
In the compass mode, press the [select] button once to enter this sub mode.
In the Declination Adjustment mode (Fig. 55):
• Field 1 displays the declination direction “OFF” where OFF = no declination; W = West; E = East.
• field  displays declination in degrees.
• field 3 displays the text “dec”.