Connecting antennas, Fm indoor antenna (aerial), Am indoor antenna (aerial) – Onkyo TX-SR500E User Manual
Page 14: Antenna
14
Connecting the supplied FM and AM indoor antennas (aerials)
Connecting antennas
FM indoor
antenna (aerial)
Note
Insert one end of the AM antenna (aerial) cord to either of the AM antenna (aerial) connectors and the other end to the other connector. There
is no difference between one end of the AM antenna (aerial) cord and the other end, unlike the speaker cables which have positive and
negative poles.
Adjusting the position of the AM indoor antenna (aerial)
The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as
possible from the TX-SR500/TX-SR500E, televisions, speaker cables, and power cords.
When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.
AM indoor antenna
(aerial)
ANTENNA
FM
75
AM
Insert into the
hole.
Rotate the outer frame
of the antenna.
Extend the
antenna cord.
Press up and hold
the lever.
Insert the end of the
cord.
Release the lever to
secure the connection.
REMOTE
CONTROL
R
L
R
L
R
L
IN
IN
IN
COAXIAL
OPTICAL
1
2
IN
IN
IN
IN
FRONT
SURR
CENTER
SUB
WOOFER
VIDEO 2
VIDEO 1
OUT
OUT
OUT
DIGITAL INPUT
VIDEO 2
VIDEO 1
DVD
MONITOR
OUT
VIDEO
S VIDEO
DVD
TAPE
CD
FRONT
SPEAKERS A
FRONT
SPEAKERS B
SURROUND
SPEAKERS
CENTER
SPEAKER
L
R
L
R
AC OUTLET
120 V
VOLTAGE
SELECTOR
220-230 V
ANTENNA
FM
75
AM
SUBWOOFER
PRE OUT
ANTENNA
Adjusting the position of the FM indoor antenna (aerial)
The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is
received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.
ANTENNA
FM
75
AM
North American models
1
Strip away the insulation from
the end of the cord.
2
Fully insert the stripped end of
the cord.
Except for North American models
Fully insert the end of the cord.