Quantum LTO-2 - Manual (Page 22)

Chapter 2 Installation and Quick Start
Installing an Internal LTO-2 Half-Height Tape Drive
8 LTO-2 Half-Height Tape Drive User’s Guide
• SCSI ID: 6
• Terminator power: disabled
If you need to change these settings, refer to the following sections.
Otherwise, skip to Mounting the Internal Tape Drive on page 11.
SCSI ID 2
• Jumper Pins: 1–2, 3–4, 5–6, 7–8
• Default Setting: SCSI ID 6
Each SCSI device on the bus must have its own unique SCSI ID. The
internal tape drive is shipped with a default SCSI ID of 6. If another SCSI
device in the SCSI chain is using this ID, use jumper pins 1–2, 3–4, 5–6,
and 7–8 to change the SCSI ID of the LTO-2 Half-Height Tape Drive (see
figure 2 and table 1 ), or assign a unique SCSI ID to the other SCSI device.
Note:
The SCSI controller or host adapter generally uses ID 7. In
some systems, the boot drive uses ID 0 or ID 1. Avoid setting
your drive’s SCSI ID to these settings.