Quantum LTO-2 - Manual (Page 53)

Chapter 5 Specifications
Drive Performance Specifications
LTO-2 Half-Height Tape Drive User’s Guide 39
Drive Performance Specifications
5
Table 7 lists the performance specifications for the LTO-2 Half-Height
Tape Drive.
Max Continuous Operating Power
(4)
25 watts RMS*
Max Peak Operating Power
(5)
40 watts RMS (1 sec max)
Note:
(1)
No cartridge loaded (typical drive idle current/power)
(2) Cartridge loaded and tape-threaded -- drive ready for
transfer (typical drive standby current/power)
(3)
Average drive current/power measured during
Read/Write
mode at 4.53 m/s on a typical drive.
(4)
Maximum drive current measured during
Read/Write
mode
at 4.53 m/s. Worst case 1 second RMS measurement. Measured
at the following worst case voltages (5.25V and 10.8V).
(5)
Peak current/power, RMS current measured for maximum
current do not occur at the same time max current condition.
(1-5)
RMS parameters measured at the power connector using a
nominal voltages of 5.0V and 12.0V unless stated otherwise.
Specification LTO-2