Install the cpsmp-200, Connect to external power – Transition Networks CPSMP-200 User Manual
Page 3
CPSMP-200
4
Tech Support: 1-800-260-1312 -- International: 00-1-952-941-7600 -- (24 hours)
WARNING: Do not connect the power supply module to the external power
source before installing it into the chassis. Failure to observe this caution could
result in equipment damage and/or personal injury or death.
Install the CPSMP-200
NOTE: The CPSMP-200 power supply module may be “hot swapped” (i.e.,
installed in the chassis while the chassis is in operation) provided the module
to be installed has been disconnected from its external power source and the
module’s On/Off switch has been set to “0”.
To install the CPSMP-200 as the redundant power supply module into either
the CPSMC18xx-xxx or the CPSMC19xx-100 PointSystem™ chassis:
1.
Remove and retain the two (2) screws that secure the protective plate to
the rear of the chassis and pull the plate away from the chassis.
2.
Set the On/Off switch on the power supply module to “0”.
3.
Set the Primary/Secondary switch and the Management/Manual switch, if
necessary (see page 3.)
4.
Carefully slide the power supply module into the installation slot,
aligning the module with the installation guides. Ensure that the power
supply module is firmly seated against the chassis backplane.
5.
Carefully install the two (2) screws (retained in step 1) through the power
supply module and into the chassis. Rotate the screws clockwise to
secure.
I
0
I
0
I
0
Primary/Secondary Switch
and
Management/Manual Switch
[email protected] -- Click the “Transition Now” link for a live Web chat.
5
Connect to External Power
CAUTION: Ensure that the On/Off switch on the power supply module is
set to “0” when connecting to the external power source. Failure to observe
this caution could result in damage to, and subsequent failure of, the power
supply module.
To connect the CPSMP-200 to external power:
1.
Set the On/Off switch on the power supply module to “0”.
2.
Connect the female end of the AC power cord to the male end of the AC
power connector.
3.
Connect the male end of the AC power cord into the correct voltage AC
rack or wall socket.
4.
Set the On/Off switch on the power supply module to “I”.
5.
Verify that the CPSMP-200 power supply module is powered by
observing the fan and the illuminated power LED.
I
0
Fan
Power LED AC Power Connector
On/Off Switch
AC Power Cord