Technicolor - Thomson RP5430 - Manual (Page 31)

Location of Controls and Functions Operator's Manual LDK 200 Triax 4-7
Monitoring Functions
1
1 CVBS output connector
This BNC connector provides a 1Vpp CVBS output
signal when the optional encoder (LDK 5405/00
for PAL or LDK 5405/50 for NTSC) is fitted.
2
2 Viewfinder / External video output
connector
This BNC connector carries the viewfinder signal or
the external video signal from the Base Station
depending on the position of switch
3 .
3
3 Video output selection switch
This switch determines whether the viewfinder signal
from the camera or the external video signal
from the Base Station is available at connector
2 .
4
4 External signal selection switch
This switch selects either the EXT1 or EXT 2 signal
for display in the viewfinder when the viewfinder
signal selection switch
6 is in the EXT position.
5
5 Viewfinder selection switch
This switch is used to select the camera Y signal or
an external signal - set with 6 - for display in the
viewfinder. The Ret. button on the lens also
selects this signal in parallel with this switch.
6
6 External signal selection switch
This switch selects the signal displayed in the
viewfinder when the viewfinder signal selection
switch
5
is in the EXT position. The signal
displayed is as follows:
EXT : Base Station external input 1.
MIX : Base Station external input 1 and
camera Y signal mixed.
Note: Switches 5 and 6 are disabled when the
SuperXPander is used.
7
7 Tally switch
The tally switch is used to control the tally indicator at
the front of the viewfinder.
When this switch is set to the ON position, the tally
indicator light when the camera is on-air.
When this switch is set to the OFF position, the tally
indicator does not light when the camera is on-
air.
The tally swith does not control the tally indicator at
the rear of the carrying handle.
8
8 Tally indicators (red)
The red tally indicators at the front of the viewfinder
and at the rear of the carrying handle light to
indicate that the camera is on-air. the tally
indicator at the front of the viewfinder does not
light when the camera is on-air if the tally switch
is set to the OFF position.
Call
Mic
VF
Front Rear 48V
Ext
Scrip
Light
Breaker
Power on
DC in
CVBS (option)
Eng
Prog
r
Prod
Eng
Off
Prod
Ext
Mix
Front
Rear
Loc
TP
Mic 2
48V On
12V 1,5A DC Out
Ext 2
Ext 1
1
2
3
4
5
6
7
8