Tally Genicom Tally Dot Matrix T2250 - Manual (Page 15)

Paper handling
This section describes how to set the paper type, load fanfold paper and single sheets, transport
paper and move the paper to the tear position.
➤ Paper path quick
selection You can change the paper type either from an application program, by means of the paper path
quick selection feature or in the Setup menu. In this section, the quick selection feature is
described; for detailed information on how to make this setting via the Setup menu, refer to the
reference manual on the online CD-ROM.
Make sure that the printer is in offline mode; press the Online key, if necessary.
Press the Park (1) key and follow the messages in the display. If fanfold paper
is loaded in the printer, it is fed to the tear position. The text Tear paper off
appears in the display. Then press any key. If a single sheet is loaded in the
printer, it is ejected.
Use one of the marked keys to select the desired paper path, for example,
Single (2).
The display alternates between the basic menu and the menu in the following
figure:
Insert a single sheet (for the procedure, see page 14, Loading paper).
Press the Online key to set the printer to ready status. When the printer receives
data from the computer, the single sheet is automatically loaded. Press the
Load (4) key to load the single sheet before starting the printout.
Offline Tractor1
Park Load
Online
Setup
2 1 3 4
Single Tractor1 Single Tractor1
Online Online
Setup Setup
ASF-R Next ASF-R Next
22 11 33 44
If the printer has the standard paper sources only (Single sheet and
Tractor 1), please select from these only.
If you do not make a selection within 5 seconds, the menu is closed.
Load paper from
Single Online
Setup
2 1 3 4
Online Single
Load Online
Setup
2 1 3 4
E
N
G
L
IS
H
Quick Start-up Paper handling
13