Tally Genicom Tally Dot Matrix T2250 - Manual (Page 21)

Settings
This section describes how to set the tear position, the first printing line, the print head gap as
well as the font and the character density.
➤ Setting the tear
position If the tear position of the paper is not aligned with the tear edge of the printer, you can adjust it.
Loaded paper may have to be torn and repositioned to the park position.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key.
Press the < (2) or > (3) key to move the perforation to the desired position.
Confirm the setting by pressing the Set (1) key.
Press the Setup key. The printer is reset to the initial status.
Adjust Paperway
Menu Char
Online
Setup
2 1 3 4
TOF
Head Tear Online
Setup
2 1 3 4
TearAdj= 00/72"*
Set < > Exit
Online
Setup
2 1 3 4 The correction made will be retained after switching off the printer.
E
N
G
L
IS
H
Quick Start-up Settings
19