TANDBERG Hub - Manual (Page 19)

TANDBERG 3G Gateway User Manual
Source shows the Status of the incoming call to the 3G Gateway, the number and which network
the incoming call is using.
Destination shows the Status of the outgoing call from the 3G Gateway, the number and which
network the outgoing call is using.
Idle
No active call, call has been disconnected.
Alerting
Call is being connected, i.e. ringing state.
Connected
Call is connected.
Number
ISDN or IP number.
IP/H.323
Call connected is using the H.323 protocol over IP.
Duration
Shows the length of the current call.
Status
Shows current status of the PRI and IP status.
PRI:
PRI line is synced and active. Click on More... to see status in detail.
PRI line is not active. Click on More... to see status in detail.
IP/H.323:
The gateway is registered with a Gatekeeper. Click on More... to see status in
detail.
The gateway is not registered with a Gatekeeper. Click on More... to see status in
detail.
Usage
The usage bar shows the current status of all the available resources (CPU, ISDN channels and
number of calls)
When the Resource Usage reaches the “Busy on Load”-limit, the gatekeeper will try to route
outgoing IP calls to other gateways. This is done to maintain availability for incoming UMTS calls
when using multiple gateways.
Resource Usage 90%. Click on the Usage link to see resource usage
in detail.
H.323 Busy on Load> 70%. Click on the Load link to adjust the value.
19