TANDBERG Hub - Manual (Page 37)

TANDBERG 3G Gateway User Manual
5.3 IP Configuration
To configure the IP settings on the 3G Gateway, open ‘IP’ as shown in the figure below.
IP Configuration Interface1
IP Address Assignment
DHCP:
Dynamic Host Configuration Protocol can be selected when a DHCP server is
present. Static IP Address, Static IP Subnet Mask and Static IP Gateway are
ignored because these parameters are assigned by the DHCP server.
Static: If Static assignment is used, the 3G Gateway’s IP address and IP subnet mask
and the Gateway’s IP address must be specified in the respective IP address
fields.
Address
The Static IP Address defines the network address of the 3G gateway. This address is only used
in static mode. Your LAN administrator will provide you with the correct address for this field.
Subnet Mask
The Static IP Subnet Mask defines the type of network. Your LAN administrator will provide the
correct value for this field.
Gateway
The Static Gateway IP address is set to 127.0.0.1 by default. In case of a router enter its address
here. Your LAN administrator will provide the correct value for this field.
37