Binatone JE-800 - Manual (Page 6)

6
BEFORE FIRST USE
Read the instruction manual below.
Remove all of the packing materials from the
juicer.
Wash thoroughly all of the juicer parts that may
contact the food.
Check if the appliance is assembled properly
(see section “Assembling”).
INSTRUCTION MANUAL
Assembling
1. Place the juicer upon a dry clean horizontal sur-
face.
2. Place the separator (6) upon the juicer case
(10) at approx. 30–40° angle and fix it by turn-
ing counter-clockwise until a click is heard (see
Picture B).
3. Put the grater-filter (9) over separator (6) so that the former locks
on its fixing piece (11); check if it rotates freely.
Note: when disassembling the appliance remove the grater-
filter (9) together with the separator (6); to do that
turn the separator clockwise at 30–40°, pull it
upwards, and then remove the grater-filter (9).
4. Close the juicer with the lid (3). To do that, press the latches (4)
upper parts, carefully put the lid on the separator (6) and release
the latches to firmly fix the lid on the juicer case. Check if the lid is
fixed properly.
Note: Your juicer is equipped with an automatic protection
system. The appliance will not work if the latches (4)
or the lid (3) are not closed and it will automatically
turn itself off if they are accidentally opened during
the process.
5. Place the pulp collector (14) under the pulp outlet (8), then put the
measuring glass for juice (13) under the separator nozzle (6).
The foam separator is intended to separate the foam from the juice.
Collect the juice in the main compartment of the measuring glass
(13), and whilst serving it through the spout - the foam will remain
at the bottom of the measuring glass (13). You may use any other
jug of appropriate size instead of the measuring glass (13).
6. Your juicer is has as anti-drip system. When the appliance is not in
use, snap up the nozzle (7), which will prevent the juice dripping
onto your table. Before using the juicer always open the nozzle
(7) to prevent juice from lingering in the separator. Never load
products into the juicer with the nozzle shut.
7. Install the hopper (2) on the product inlet (5) so that you may place
the fruit and vegetables there while making juice. Because the hop-
per (2) profile is exactly the same as the lid (3) one, when putting
the juicer away for storage just turn the hopper over to save space.