Binatone JE-800 - Manual (Page 7)

7
ENGLISH
Usage
1. Before plugging your juicer in check that the switch (12) is in “0”
position and that the latches (4) are properly closed.
2. Prepare the food for processing. To achieve the best performance
of your juicer always observe the following rules:
Cut the food into medium sized pieces; small pieces reduce the
juicer productivity.
Do not load more than one piece of product at a time into the
product inlet (3). Load the next piece after the previous one is
fully processed and the juice stopped coming out of the nozzle.
After putting the product pieces into the product inlet (3) slowly
push it through to the processing zone using the pusher (1), do
not use excess force.
3. Place a glass under the separator nozzle (6). Open the nozzle (7).
4. Turn the juicer on by selecting appropriate speed with switch (12).
For the best juicer performance use speed 1 for softer food (e.g.
apples) and speed 2 for harder foods (such as carrots).
5. Lower the sliced fruit into the product inlet (5) and push then inside
gently with the pusher (1). Do not use excess force it will only
reduce the juicer productivity.
6. When you lower the sliced fruit or vegetables into the juicer, the
motor should not stop.
7. If in the process the pulp collector (14) gets full, switch the appli-
ance off and take the pulp collector out of the juicer by the handle.
Clean the collector and install it on its place again. Switch the juicer
on to resume the work.
8. After use wash the juicer and thoroughly dry all of its components.
CARE AND CLEANING
1. Unplug and disassemble the juicer.
2. To avoid accidents do not immerse the juicer
case (10) into water or any other liquid. Just
wipe it with cloth soaked in soapy water.
3. We recommend you to wash all other juicer
components in soapy water using soft sponge.
Do not use scrubbers or abrasive detergents.
4. Some foods, e.g. carrot, oranges, etc. will stain the plastic to re-
duce this, try a solution of 2–3 teaspoonfuls of 9% vinegar in a
glass of water. After that rinse the components with water as usual.
5. To avoid the juicer choking up after each use wash the separator
nozzle (7). To do that, remove the nozzle from the separator (6).
Remove separator (6) from appliance by pulling the nozzle from
below, then pull it off the fixing prongs (see Picture C). Atten-
tion: the nozzle (7) is inseparable! Thoroughly wash the sepa-
rator (6) and nozzle (7), then replace the nozzle reversing the
procedure. Do not use the juicer without the nozzle (7).
6. To avoid damages handle the grater-filter with care (9). Improper
use of this component may result in breakage. Observe the fol-
lowing maintenance rules:
– Wash the grater-filter with a soft brush.
– Do not use detergents containing chlorinated lime and metal
brushes.
– In case the grater-filter gets damaged you should replace it
with a new one.