Texas Instruments DAC3482 - Manual (Page 15)

www.ti.com Optional Configuration
(baseband = 30MHz, NCO disabled, QMC Gain = 1024)
Figure 13. DAC3484 Transformer Coupled Output at 30MHz IF
4.2 Using the DAC3482 or Configuring DAC3484 in DAC3482 mode
The DAC3484 EVM can also be used to evaluate the performance of DAC3482, or configure the
DAC3484 in Dual-DAC mode instead of the Quad-DAC mode. For DAC3482 or DAC3484 in Dual-DAC
mode, only the Inner Channels (B and C) are functional and the other two channels (A and D) are
disabled. The software can be configured as DAC3482 interface by selecting DAC3482 EVM Software
Control from the upper left-hand corner of the pull-down menu.
The DAC3484 EVM needs to be configured differently for the DAC3482 mode with the TRF3703-15
modulator. The inner DACs need to be routed to the third TRF3703-15 modulator in the middle.
To enable the DAC3482 Dual DAC with the TRF3703-15 interface, do the following board
modifications:
1. Remove R136, R278, R277, and R279 zero ohm jumpers
2. Install R137, R138, R246, R261
Refer to Figure 14 for locations of these zero ohm jumpers.
15 SLAU336 – March 2011 DAC3484/DAC3482 EVM
Submit Documentation Feedback
© 2011, Texas Instruments Incorporated