Tascam RC-898 - Manual (Page 66)

Section 10.1 - Menu groups
10-2
Menu group 1
Menu group 2
Menu item Parameter(s) Values Reference
GPI Setup Polarity
Width
open , close
000 through 990 ms (in 10ms steps)
9.2.1, “Setting up
GPI devices”
Event GPI Event Number 1 through 10
GPI “channel” 1 through 5
00 (off) through 99
9.2.2, “Setting the
trigger points”
Pre-roll
Post-roll
Minutes and
seconds Pre-roll time: 00min05sec through
59min59sec
Post-roll time: 00min03sec through
59min59sec
6.7.5, “Setting pre-
roll and post-roll
times”
Crossfade Time Milliseconds 10ms through 200ms in 10ms steps
10ms through 90ms in 10ms steps
6.7.6, “Crossfade
times”
Dither Type of dither or
on and off off , Rectangular ( = on) ,
Triangular
7.2.11, “Dither”
Rec Mute Track muting on or off for each track 7.1.3, “Rec Mute
function”
Menu item Parameter(s) Values Reference
Shuttle Mute Enabled off or on 5.2.4, “Shuttle mut-
ing”
TDIF Word Length Length in bits,
of incoming
data 16 bit , 20 bit , 24 bit 7.2.10, “Word
length”
Analog In/Out
Reference Level
Reference level,
in dB -16dB , -18dB , -20dB 7.2.13, “Reference
levels”
Level Meter Mode Hold time
Release rate
0 through 9 seconds, or Continue
(default is 1 )
Slow , Fast or Medium
7.2.14, “Meter
modes”
Sine Oscillator Enabled off , 440 Hz , 1 k Hz 7.2.15, “Sine oscilla-
tor”
G P I S e t u p X - f a d e
E v e n t D i t h e r
P r e / P o s t R e c M u t e
98
38 88
98 38
98
98
S h t l M u t e M e t e r M o d e
W o r d L e n S i n e O s c .
R e f L e v e l
98
38 98
98
98
98