Tascam RC-898 - Manual (Page 69)

10.1 - Menu groups
10-5
Menu group 7
Menu group 8
Menu item Parameter(s) Values Reference
MTC Output Output
Fast wind mode
Stop
(All parameters ) on , off
on , off
on , off
8.2.7, “MIDI Time-
code output”
MIDI/Bus ID ID for MMC
and bus control 001 through 127 or Receive
All
9.4.9, “MMC ID”
9pin Locate Pre-
roll
Preroll time for
P2 device 00min00sec through 59min59sec in
1 second increments
9.3.2, “Location pre-
roll on the serial
unit”
9pin Control
Mode Recording status
when using P2
device Split , Normal 9.3.4, “Split mode
on the serial unit”
9pin Time Mode Time source for
P2 device Timecode , Timer 1 9.3.3, “Serial unit
timing source”
9pin Rec Accept-
able
Record enable
for P2 device On , Off 9.3.5, “Controlling
recording opera-
tions on the serial
unit”
Menu item Parameter(s) Values Reference
Generate Start
Time Time value Defaults to 00:00:00:00 8.1.4, “Setting the
generator start time”
Generate Mode Run/Stop
Mode
Stop , Run
Reset , Continue
8.1.5, “Starting and
stopping the genera-
tor”
Fs Shift Mode Pull up/down
parameters off , Pull Down 30NDF ,
Pull Up 29.97NDF , Pull Up
29.97 DF , Pull Down 30 DF
( only)
8.2.3, “Pull up and
pull down”
TC Record Source Source to be
used for record-
ing on the time-
code track External TC , Generator
TC, Tape
a
a. If Tape is selected, another parameter will automatically be appended, depending on the setting made in the appropriate
menu, as described in 8.1.1, “Selecting the timecode source”
8.1.1, “Selecting the
timecode source”
TC Track Record Arming the
timecode track enable , disable 8.1.7, “Recording
the timecode on a
DTRS timecode
track”
M T C O u t M I D I I D
9 p i n L o c P r 9 p i n C t l M d
9 p i n T i m M d 9 p i n R e c A c
98
98
G e n S t a r t F s S h i f t
G e n M o d e T c R e c S r c
T c T r k R e c
98 88
98 88
98 88
98
98
98 88