Teledyne Field Wizard 2101 - Manual (Page 21)

2101 Field Wizard
Section 2 Preparation and Installation
2-7
2.4.2 Communication
Connectors
Connecting the Field Wizard module involves uncapping and
capping communication connectors. When a communication con-
nector is not in use, the connector should always be capped
(Figures 2-6 and 2-8). The cap will seal the connector to prevent
corrosion, and will improve communications.
When a communication connector is in use, store the cap on the
holder next to the connector (Figures 2-7 and 2-9). The communi-
cation connector will be sealed by its mating connector.
CAUTION
Caps PUSH ON and PULL OFF. Do not rotate the caps to
remove them from the connectors.
Capuchons POU SSER et TIR ER. Ne pas tour ner les
capuchons pour les enlever des prises.
Note
For modules to correctly stack and lock together, protective
caps between the modules must be stored on the holders.
2.4.3 Stacking Modules To stack a Field Wizard Module on a 2100 Series Module, follow
the instructions in Figures 2-10 through 2-17.
Figure 2-3:
2100 Series Module’s Upper
Connector - Capped
Figure 2-4:
2100 Series Module’s Upper
Connector - Uncapped
Figure 2-5:
Field Wizard’s Lower
Connector - Capped
Figure 2-6:
Field Wizard’s Lower
Connector - Uncapped