Security settings (1:2) – TANDBERG Media Processing System MPS 200 User Manual

Page 139

Advertising
background image

D 13373.08
NOVEMBER 2007

MPS

Table of

Contents

TANDBERG

MPS

ADMINISTRATOR GUIDE

Conference Template

Security Settings (1:2)

Conference Template Configuration

The Conference Templates are found in the MCU Configuration tab.
The predefined settings will be used as default settings when creating
new conferences based on this specific template. TANDBERG MPS
enables the setup of 10 different conference templates.

The conference template contains the same settings as de-
scribed in the

Create Conference

in the Overview section.

Conference Template Configuration

Password

To ensure only authorized participants are able to join this conference
you can set a password. Then the participants must enter the pass-
word to join this conference. The password can be numerical only.

When dialling into a password protected conference, the partici-

pant is met with the ‘Password Enquiry’ screen and sound, asking
the participant to enter a password. This can be performed via a
menu generated by the videoconferencing system (H.243 Pass-
word) or via DTMF (telephone) tones.

Until the correct password is entered, the participant will not be

able to hear or see any of the other participants. After entering the
correct password and confirming (typically by pressing ‘OK’ or the
hash key), the participant will join the conference.

Should the password be incorrect, the participant is met with the

‘Password Incorrect’ screen and after a few seconds, the ‘Pass-
word Enquiry’ screen and sound appear again. If the participant
enters a wrong password three times, the participant will be
disconnected.

With no password entered in this field, participants can join the

conference without entering a password

Password Out
On:

When set to On and dialling out from a password protected con-

ference, the participant is met with the ‘Password Enquiry’ screen and
sound, asking the participant to enter a password. This setting can be
used to ensure that only authorized participants are able to join the
conference also when dialling out from the conference.

Off:

When set to Off no password is required when dialling out.

Press

Save

to activate the new settings

139

Introduction

Quick

Setup

Using

the MPS

System

Status

System

Configuration

Installation

Gateway

Configuration

Technical

Descriptions

Appendices

Main

MCU

Configuration

Advertising
This manual is related to the following products: